As some of you may know I recently took apart my gears to put in a new cable, and rather than do it the simple way I destroyed the gear lever first to put it in before spending a few hours putting the whole thing back together again. Lesson No.1 learnt.
Well tonight I decided to see why my back brake was not working by taking it apart (doh!), all it needs is new brake pads but I managed to loose brake fluid while taking it all apart so it has prempted a slightly early brake bleed, which I haven’t finished yet as I have no spares and very few tools.
Maybe someone should write some HowTo things for this here site to stop any further blunders that I am bound to make.
Learning (the hard way) is fun 
July 8th, 2008 at 6:56 pm
Yo have a deek at this marra-
http://www.parktool.com/repair/
it has all u need to know, i used it when i ran a repair course a few years back.
alternatively let me at it!!!
July 8th, 2008 at 6:57 pm
http://www.parktool.com/repair/readhowto.asp?id=126
more specific
July 8th, 2008 at 9:38 pm
It’s all connected up again and nearly working might pop and see you on Saturday to double check it all though still needs adjusting to work properly.
July 8th, 2008 at 11:38 pm
for feks sake don’t bring it into the shop or i will have to charge u labour. i could look at it round at Ems or Dans on Saturday night .